Need help?Do you have a question about the LG Flatron ez T910B and is the answer not in the manual?
Details on CRT size, signal levels, power input, and connector types.
Active display area, resolution, bandwidth, operating temperature, and altitude.
Power usage by mode, overall dimensions, and weight of the monitor.
Identifies critical safety components and warns against unauthorized modifications.
Emphasizes using isolation transformers and proper lead dress in high voltage areas.
Outlines precautions for measuring and maintaining high voltage to prevent X-radiation.
Details timing specifications for horizontal synchronization across different modes.
Details timing specifications for vertical synchronization across different modes.
Lists supported display resolutions and their corresponding refresh rates.
Identifies buttons like Menu, Select, Brightview, Power, and navigation arrows for OSD control.
Explains the power indicator light and direct access functions for brightness/contrast.
Identifies VR801 for High Voltage and VR901 for B+ voltage adjustments.
Highlights DY-Pin, Anode Cap, Degaussing Coil, and various board connectors for wiring reference.
Step-by-step guide to removing the monitor's back cover and tilt/swivel mechanism.
Instructions for carefully detaching the main chassis assembly from the monitor housing.
Covers signal input, MICOM, E2PROM, OSD IC, and associated control circuits.
Details H/V sync, deflection drivers, high voltage generation, SMPS, and protection circuits.
Covers degaussing, linearity, focus, and tilt correction functions.
Explains Line Filter, SMPS, Power Management, X-ray Protection, Micom, and Sync Processor functions.
Details deflection, High Voltage, Linearity, Moire, Rotation, OSD, and Video signal circuits.
Notes on tools, alignment, and procedures for automatic/manual degaussing.
Steps for adjusting B+ voltage to 190V and High Voltage to 27kV using specific potentiometers.
Procedures for setting factory modes and adjusting white balance and luminance levels.
Detailed steps for color calibration, including BIAS, DRIVE, and LUMINANCE adjustments.
Procedures for loading EDID data and fine-tuning the focus control on the FBT.
A flowchart guiding diagnosis of power-related problems, starting with the fuse and power indicator.
A flowchart for diagnosing problems where no text or characters are displayed on the screen.
A flowchart for diagnosing situations with no video output or raster scan, checking power indicator and voltages.
A flowchart for diagnosing issues where the image lacks vertical display, checking deflection IC pins and waveforms.
A flowchart for diagnosing failures in Stand-by, Suspend, or Off modes, checking MICOM signals and power lines.
A flowchart for diagnosing failures in the degaussing circuit, checking MICOM, transistors, relay, and coil.
A flowchart for diagnosing OSD issues, checking IC301 signals and front control inputs.
Lists replacement part numbers and specifications for capacitors and diodes.
Continues the list of replacement capacitors and diodes with their part numbers and specifications.
Lists replacement part numbers for diodes, integrated circuits, coils, and transistors.
Lists replacement part numbers for transistors and resistors with their specifications.
Continues the list of replacement resistors with their part numbers and specifications.
Lists remaining resistors and other parts like switches, transformers, and variable resistors.
Details the pin functions for the TDA4866J vertical deflection booster IC.
Details the pin functions for the M62501P/FP chip used for OSD or related functions.
Shows the component placement and routing on the solder side of the control PCB.
Shows the component placement and routing on the solder side of the main PCB.
To Next Page
General
