- 15 -
Copyright 2007 LG Electronics. Inc. All right reserved.
Only for training and service purposes
LGE Internal Use Only
(3) Adjustment of RGB
Model : 3 / Pattern : 65
6. ADC Calibration (The case where
does not become Substrate ADC
Calibration)
6.1. Adjustment of RF/AV
* Required Equipments
- Remote controller for adjustment
- MSPG-925FS Pattern Generator (Which has Video Signal
: 7 Color Bar Pattern shown in Fig. 1)
=> Model: 202 / Pattern: 65
(1) Method of Auto RF/AV Color Balance.(PAL_BGDHI)
1) Input the Video Signal : 7 Color Bar signal into AV1 or
AV2.
2) Set the PSM to Dynamic mode in the Picture menu.
[Fig.1]
3) Press IN-START key on R/C for adjustment.
4) Press the
G (Vol.+) key to operate the set, then it
becomes automatically.
5) Auto-RGB OK means the adjustment is completed.
6.2. Adjustment of Component
* Required Equipments
- Remote controller for adjustment
- MSPG-925FS Pattern Generator (Which has 720p/50Hz
YPbPr output Pattern shown in Fig.2)
=> Model : 215 / Pattern : 65
(1) Method of Auto Component Color Balance
1) Input the Component 720p/50Hz 7 Color Bar(MSPG-
925FS model : 215, pattern : 65) signal into Component.
2) Set the PSM to Dynamic mode in the Picture menu
[Fig.2]
3) Press the IN-START key on R/C for adjustment.
4) Press the
G (Vol.+) key to operate the set , then it
becomes automatically.
5) Auto-RGB OK means the adjustment is completed.
6.3 Adjustment of RGB
* Required Equipments
- Remote controller for adjustment
- MSPG-925F Pattern Generator
(Which has XGA [1024*768] 60Hz 8 Color Bar 100%
pattern shown in Fig.3)
(1) Method of Auto RGB Color Balance
1) Input the PC 1024x768@60Hz 7 Color Bar (MSPG-925F
model : 60, pattern : 65) signal into RGB (Using D-sub to
D-sub cable)
2) Set the PSM to Dynamic mode in Picture menu.
3) Press the IN-START key on R/C for adjustment
[Fig.3]
4) Press the G (Vol.+) key operate To set , then it becomes
automatically.
5) Auto-RGB OK means adjustment is completed.
* Before adjusting White-balance, the AV ADC should be
done.
To Next Page
Loading...
