15
16. Use the spanner ⓖ to check the dimension. (See Figure 14)
15. Loosely fix the top bracket ⑩ with the height adjusting nuts ⓓ (Figure 13), and adjust the
depth gap between the integrated door panel and the front of the cabinet to 4mm. At this
time, adjust the location of the integrated door panel so as not to touch or make contact
with the face of the cabinet when opening/closing the door.
17. If the dimension is not correct, loosen the height adjusting nuts ⓓ, the door screw ⓐ
and the wood screw ⓑ, and repeat the work starting from Step 12.
6. Procedure to install
4) Refrigerator door related work
d
d
g
10
18. Place the depth adjusting bracket ④ as shown at the figure, fix it with the bracket screw
ⓔ (two spots), and fix with the top bracket screws ⓒ (four spots). (See Figure 15)
Secure the height adjusting nuts ⓓ to fix the top bracket ⑩.
(Figure 15)
c
4
e
To Next Page
Loading...
