HOW TO USE
Before use
Clean the fridge.
Clean your fridge thoroughly and wipe off all dust that may have accumulated during
shipping.
NOTE
Remove adhesive residue by wiping it off with your thumb or dishwashing
detergent.
CAUTION
Do not scratch the fridge with a sharp object or use a detergent that contains
y
alcohol, a flammable liquid or an abrasive when removing any tape or
adhesive from the fridge.
Do not peel off the model or serial number label or the technical information
y
on the rear surface of the fridge.
Connect the power supply.
Check if the power supply is connected before use.
Read the “Turning On The Power” section. (Your plug type might be different from
the picture.)
CAUTION
Putting food in the fridge before it has cooled could cause the food to spoil, or
a bad odor could remain inside the fridge.
Wait for the fridge to cool.
Allow your fridge to run for at least three to four hours before putting food in it.
Check the flow of cold air in the freezer compartment to ensure proper cooling.
The fridge makes a loud noise after initial operation.
This is normal. The loudness will decrease as the temperature lowers.
Before Plugging in, open the fridge doors to ventilate the interior.
The inside of the fridge may smell like plastic at first. Remove any adhesive tape
from inside the fridge and open the fridge doors for ventilation until any odors have
subsided.
To Next Page
Loading...
Need help?
General
