31
OPERATION
ENGLISH
3) After 5 seconds of idle time, the last mode set will be saved, and the display will return to normal.
l
Water & Ice Type
*1
Select the desired dispenser mode from the buttons on the dispenser control panel. Press the 
dispenser switch with a glass or other container to dispense cubed ice, water or crushed ice.
•  For optimal food preservation, increasing or decreasing 1 °C from the default temperature is 
recommended for each compartment.
•  The displayed temperature is the target temperature, and not the actual temperature inside the 
appliance.
•  The actual temperature inside the appliance depends on the following factors: room temperature, the 
amount of food and how often the doors are opened, where the appliance is. Set the temperatures by 
considering these factors.
•  If there is any finger or skin contacts to the control panel while cleaning it, the button function may 
operate.
•  This appliance incorporates an earth connection for functional purposes only.
Ice and Water Dispenser
Before Using the Ice and Water 
Dispenser
•  Keep children away from the dispenser to 
prevent children playing with or damaging the 
controls.
•  Throw away the first few batches of ice (about 20 
cubes and 7 cups of water). This is also necessary 
if the appliance has not been used for a long 
time.
•  Clean the water dispensing system if they have 
not been used for 48 hours. Flush the water 
system connected to a water supply if water has 
not been drawn for 5 days.
•  To clean the water dispensing system, flush the 
water through the dispenser about 5 minutes 
and throw away the first few batches of ice.
•  Do not use a thin crystal cup or chinaware when 
dispensing water or ice.
•  If you open the freezer door while water, cubed 
ice or crushed ice is being dispensed, dispensing 
will be paused. When you close the door, the 
selected item will continue to be dispensed.
•  If the cup rim is small, water may splash out of 
the glass or miss it completely.
•  Use a cup with a rim of over 68 mm in diameter 
when dispensing water, cubed ice or crushed ice.
•  When the ice maker produces smaller ice cubes, 
or the cubes become lumped together, the 
amount of water supplied to the ice maker may 
be low due to insufficient water in the water 
tank. If ice is not used frequently or the freezer 
set temperature is too warm, it may also lump 
together.
•  It is normal for milky / cloudy water to be 
dispensed after replacing the water filter. This 
air in the water will eventually clear and is safe to 
drink during this transition.