LG GSGV81PYLL - Deodorizer Maintenance

45
MAINTENANCE
ENGLISH
3 Push the pipe into the water fitler cap, making
sure the end is fully sealed.
4 Tighten the screw cap until the colored line in
the water filter is no longer visible.
5 Press and hold the Water Filter button for
three seconds. That resets the
Replacement
Filter
icon. The new water filter has been
activated.
6 Dispense water for approximately 5 minutes to
remove trapped air and contaminants from the
system.
Push fit connector type
*1
1 Remove the screw cap.
2 Pull the pipe out from the water fitler.
3 Push the pipe into the water fitler, making sure
the end is fully sealed.
4 Insert the screw cap until the colored line in the
water filter is no longer visible.
5 Press and hold the Water Filter button for
three seconds. That resets the
Replacement
Filter
icon. The new water filter has been
activated.
6 Dispense water for approximately 5 minutes to
remove trapped air and contaminants from the
system.
CAUTION
• Failure to replace filters when required or using
non LG authorised water filters can cause the
filter cartridge to leak and result in property
damage.
Deodorizer
Reusing the Deodorizer
You can re-use the deodorizer by removing odors
from the deodorizer.