-162-
1.4.3. PWM
There are 3 PWMs.
Item Function Selection Value Description
PWM1 Freq = 0-255,
Duty = 0- 100
PWM Editor shows
the following info:
Level:[1~5]
Frequency:[0~255]
Duty:[0~100]
PWM2 Freq = 0-255,
Duty = 0-100
PWM Editor shows
the following info:
Level:[1~5]
Frequency:[0~255]
Duty:[0~100]
PWM
PWM3 Freq = 0-255,
Duty = 0-100
PWM Editor shows
the following info:
Level:[1~5]
Frequency:[0~255]
Duty:[0~100]
1. On entry of the PWM Editor,the setting of the current level is shown. Settings of all
levels can be adjusted, stored(if the ok key is pressed) and applied.
1.4.4. EINT
Display External Interrupt Status. 1 means ON, 0 means OFF.
Item Function Selection Value Description
EINT0_ACC_DET 0 0/1 Plug in the Charger
to test.
BT_EINT3 0/1 Power the Bluetooth
to test
EINT
BATTERY TEMP 0/1 Battery Test.
1.4.5. ADC
Display the ADC value. The ADC value is displayed and updated every 1 second on
this screen.
Item Function Selection Value Description
VBAT XX.XX(V) Battery voltage
Current
XX.XX(A)
Charging current
NC XX.XX(C) Battery Temperature
NC XX.XX(V) Headset send key
VChgr XX.XX(V) Charger voltage
ADC
1.4.6. Set Default Level
To Next Page
Loading...
