33Operation
Operation
4
Radio Operations
Be sure that both FM and AM aerials are
connected. (Refer to the page 21.)
Listening to the radio
1. Press
t
RADIO&INPUT until FM or AM
appears in the display window.
The last received station is tuned in.
2. Press and hold TUNING (-/+) for about
two seconds until the frequency indication
starts to change, then release. Scanning
stops when the unit tunes in a station.
or
Press TUNING (-/+) repeatedly.
3. Adjust the volume by rotating VOLUME on
the front panel or by pressing VOL (+/- )on
the remote control repeatedly.
Presetting the Radio Stations
You can preset 50 stations for FM and AM.
Before tuning, make sure that you have turned
down the volume.
1. Press
t
RADIO&INPUT until FM or AM
appears in the display window.
2. Select the desired frequency by using
TUNING (-/+)
3. Press
ENTER a preset number will ash
in the display window.
4. Press PRESET (-/+) to select the preset
number you want.
5. Press
ENTER.
The station is stored.
6. Repeat the steps 2 to 5 to store other
stations.
Deleting all the saved stations
1. Press and hold CLEAR for two seconds.
"ERASE ALL" will ash up on the unit display.
2. Press CLEAR to erase all saved of the radio
stations.
Deleting a saved station
1. Press PRESET - / + to Select a preset
number you want to delete.
2. Press CLEAR, the preset number will blink
in the display window.
3. Press CLEAR again, to delete the selectd
preset number.
Improving poor FM reception
Press
B
PLAY, MONO/STEREO on the remote
control. This will change the tuner from stereo
to mono and usually improve the reception.
HT805ST-A2.DKENHLK_ENG_9792.indd 33 2010-08-31 �� 12:02:17
To Next Page
Loading...
Need help?
General
