A12
ENGLISH
When connecting with a DVI-D signal input cable.
• Select DVI PC : DVI-D digital signal.
When connecting with a D-Sub signal input cable.
• Select RGB PC : 15-pin D-Sub analog signal.
Select an input signal.
Press the SOURCE button on the remote controller to select the input signal.
Or, press the SOURCE button at the front side of the monitor.
• How to connect to two computers.
Connect the signal cables (DVI and D-Sub) to each computer.
Press the SOURCE button in a remote controller to select the computer to use.
• Directly connect to a grounded power outlet on the wall or a power bar with a ground
wire.
Note
Turn on power by pressing the power button on the monitor.
Turn on the PC.
Power button
B
A
B
A
To Next Page
Loading...
