A38
ENGLISH
Connecting the cable
Connect the RS-232C cable
as shown in the picture.
* The RS-232C protocol is used for communication between the PC and monitor. You can
turn the monitor on/off, select an input source or adjust the OSD menu from your PC.
G Baud Rate : 9600bps (UART)
G Data Length : 8bits
G Parity Bit : None
G Stop Bit : 1bit
G Flow Control : None
G Communication Code : ASCII code
Use this method to connect several monitors to a single PC.
You can control several monitors at a time by connecting them to a single PC.
Communication Parameter
RS-232C Cable
(not included)
Monitor
PC
Controlling the Multiple Monitors
(RS-232C protocol)
To Next Page
Loading...
