5
Before Use
INTRODUCTION
Use and care of the remote control
Installing the battery
Pull out the tray outward on the back of the remote control with a
pencil or ball point pen and insert the battery with the plus (+)
minus (-) poles pointing in the proper direction.
NOTES
• Use only one CR2025 (3V) lithium battery.
• Remove the battery if the remote control is not used for a long period
of time.
•
Do not recharge, disassemble, heat or dispose of the battery in fire.
• Do not handle the battery with metallic tools.
• Do not store the battery with metallic materials.
• In the event of battery leakage, wipe the remote control
completely clean and install a new battery.
Using the remote control
Point the remote control in the direction of the front panel to
operate.
NOTES
• The remote control may not function properly in direct sunlight.
• Do not store the remote control in high temperatures or sunlight.
•
Do not let the
remote control fall onto the floor, where it may become
jammed under the brake or accelerator pedal
.
Handling the Unit
• This unit is designed to be operated on a 12 volt DC negative
ground electrical system only.
• When replacing the fuse, be sure to use fuseone with an
identically rated amperage. Use of a fuse with a higher
amperage may cause serious damage to the unit.
• Periodically wipe the contacts on the back of the front panel with
a cotton swap moistened with alcohol.
To Next Page
Loading...
Need help?
General
