- 21 -
7. Disconnect the connecting points
between tub and base
1) Disconnect noise filter.
(Not on all models)
2) Disconnect of powercord assembly.
3) Disconnect wire from the capacitor.
6. Remove the side screws
1) Remove side 8 screws.
2) Remove 2 Earth screws of right side.
3) Remove 1 motor bracket screw.
4) Lift base upward slightly.
(You can’t lift up base perfectly because of
some parts connecting to base.)
3828DD3007H(S/M) 2008.2.18 4:25 PM 페이지21 001 GateRip_A3
To Next Page
Loading...
