- 33 -- 33 -
7. Disconnect the connecting points
between tub and base
1) Disconnect noise filter.
(LD-1426T/1416T/1415M)
2) Disconnect of powercord assembly.
3) Disconnect wire from the capacitor.
6. Remove the side screws
1) Remove side 8 screws.
2) Remove 2 Earth screws of right side.
3) Remove 1 motor bracket screw.
4) Lift base upward slightly.
(You can’t lift up base perfectly because of
some parts connecting to base.)
To Next Page
Loading...
