5-1
CONVERSION TO LP GAS
Tools required
• Adjustable wrench
• 13/32” or 10mm open-end wrench
5/16” or 8mm open-end wrench
• Phillips head screwdriver
• Flat bladed screwdriver(blade width approximately
3/32” across)
• Nut drivers : 13/32” or 10mm
5/16” or 8mm
1. PREPARE RANGE FOR CONVERSION
1) Turn off gas supply to the range.
2) Turn off the electrical power to the range.
WARNING
• Turn off the electrical supply and
gas supply going to the range.
• Replace all panels and parts before
operating.
•
RECONNECT all grounding devices.
- Failure to do so can result in severe personal
injury, death or electric shock.
CAUTION
• Use caution when handling sheet
metal parts while servicing the
range.
- Some parts may have sharp edges, which
could result in injury.
CAUTION
• If the gas supply to the range is
disconnected for any reason see
the installation instructions for
proper connection and safety
precautions.
2. CONVERT THE GAS PRESSURE REGULATOR
The gas pressure regulator is located at the rear
of the range.
3. CONVERTING YOUR REGULATOR
1) Unscrew the hex-nut cap by using an
adjustable wrench.
2) Separate plastic cap and hex-nut cap by
turning the plastic cap to 180°.
3) Flip the plastic cap and then assemble back.
4) Screw the hex-nut cap back into the regulator.
Do not over tighten.
WARNING
• Do not remove the gas pressure
regulator from the range.
gas pressure regulator
LPG Natural
To Next Page
Loading...
