LG LFX23961SW /01 - Water Button Assmebly; Duct Door Replacement; Display Pcb; Ice Button Assembly

CAUTION: When replacing the dispenser cover in the
reverse order of removal, be careful that the lead wire
does not come out and the water tube is not pinched by
1) Remove the screw fixing the button lever.
2) Push the spring from the hanging hook to remove it.
3) Apply some pressure to the rib in
direction and lift the
button in direction.
Case, PCB Display PCB
Button Lever
- 11 -
3-12 DISPLAY PCB
As shown below, remove 1 case PCB fixing screw
the dispenser.
3-13 ICE BUTTON ASSEMBLY
Remove the display PCB fixing screw.
3-14 FUNNEL REPLACEMENT
Pull down and forward
4) If nozzle is interfered with button,
push and pull out the bottom of button
5) Remove the
connected part of
lead wire.
1
2
3-15 WATER BUTTON ASSMEBLY
2) Grasp the Button assembly and lift up.
2) Disconnect the wire harness.
3) Remove the funnel
1) Loosen the front screw as shown in the picture.
2) Lift up the hinge with one hand.
Button Lever
Hinge
1) Remove screws.
3-16 DUCT DOOR REPLACEMENT
1) Pull up and out on the dispenser cover to remove.
3-17 ICE CORNER DOOR REPLACEMENT
4) Replace in reverse order.
3) Pull out the Ice Corner Door with the other hand.