7-1 OPERATION PRINCIPLE
1. Turning the Icemaker stop switch off (O) stops the ice making function.
2. Setting the Icemaker switch to OFF and then turning it back on will reset the icemaker control.
• Adjusts EJECTOR to Start Position with power on.
Start Position
Power On
Icemaking
Mode
Harvest
Mode
Fill
Park Position
• Waits until water becomes ICE after starting the
Test Mode
icemaking operation.
• Runs MOTOR to drop ice from the tray into the ICE BIN.
(During harvest mode, check if the ice bin is full)
• Performs Ice Making Mode after supplying water by operating
the SOLENOID in ICE VALVE.
• To operate LINE and SERVICE, press and hold the Fill Key
for 3 seconds. The icemaker will run through 3 stages:
Harvest Fill Icemaking.
• Reaches Start Position
7. OPERATION PRINCIPLE AND REPAIR METHOD OF ICEMAKER
- 25 -
7-1-1 Operation Principle of IceMaker
Automatic
Icemaker
Cube Size
Indicator Light
Cube Size
Select Button
Power Switch
Shut off Arm
Ejector
To Next Page
Loading...
