8-1-5 Ice Plus selection
Please select this function for quick freezing.
* Function is repeat Ice Plus Icon whenever pressing Ice Plus button.
* Ice Plus function automatically turns off after a fixed time passes.
8-1-7 Dispenser Light
1. Freezer fan motor has high and standard speeds.
2. High speed is used at power-up, for Ice Plus, and when refrigerator is overloaded.
Standard speeds is used for general purposes.
3. To improve cooling speed, the RPM of the freezer fan motor change from normal speed to high.
4. High speed (2700RPM) : Initial power on or load corresponding operation, Ice Plus
Normal speed (2400RPM) : General working conditions.
5. Fan motor stops when refrigerator open.
2. The cooling fan runs at a single speed.
3. The Failure sensing mathod is the same as in the fan motor of the freezing fan motor(refer to failure diagnosis function
table for failure display).
1. The Icing Fan is controlled by the the sensor on the top of the ice room.
2. The Failure sensing method is the same as in the fan motor of the freezer
(refer to failure diagnosis function table for failure display)
- 29 -
PUSH
ACTIVE WATER BUTTON
WATER SWITCH
ICE SWITCH
Please select this function for DISPENSER LIGHT MODE.
1. Normal status (LIGHT icon is OFF): When dispenser is operated, DISPENSER LIGHT is ON.
2. ON status (LIGHT icon is ON): DISPENSER LIGHT is on continuously
8-1-9 Cooling Fan Motor
1. The cooling fan is switched ON and OFF in conjunction with the compressor.
8-1-10 Icing Fan
8-1-8 Control of Freezer Fan Motor
8-1-6 Dispenser Use Selection
1. Water
1) Water Switch: Hold your cup in the dispenser for a fez seconds with
pressing water switch to allow the last drops of water to fall into the cup.
2) Active water button: Place big bowl on the dispenser bottom with pressing
active water button to allow the last drop of water to fall into the bowl.
3) When after initially establishing the wqter comes out, the water tank inside
fills and until at the time of quiality the hour es caught.
2. Ice
1) You can select cube or crushed ice.
2) Select cube ice or crushed ice by cycling through the selections when
pressing the ICE OPTION button.
3) Hold your cup in the dispenser for a few seconds with pressing ice switch to
allow the last pieces of ice to fall into the cup.
To Next Page
Loading...
