- 22 -
Copyright ©2010 LG Electronics. Inc. All right reserved.
Only for training and service purposes
LGE Internal Use Only
3.2.3 UNIT INSTALLATION
1. Remove the shipping screw from the ventilation door.
(See Figure 1)
2. Remove the front gille by pulling it out at the bottom to
release it, then lift it up along the unit top front.
(See Figure 2)
3. Slide the unit into the wall sleeve and secure with 6 screws
through the unit flange holes. (See Figure 3)
4. Reinstall the front grille by hooking the top over the unit top,
then pushing it in at the bottom. (See Figure 4)
Figure 1
Figure 2
Figure 3
Figure 4
To Next Page
Loading...
