LG LP096CD3A User Manual

- 5-
Copyright ©2010 LG Electronics. Inc. All right reserved.
Only for training and service purposes
LGE Internal Use Only
1.2 CONTROL LOCATIONS
• ELECTRONIC CONTROLS
The controls will look like one of the following.
TEMP
MODE
HEAT
E
/SAVE
FANFAN
COOLCOOL
HIGHHIGH
LOWLOW TIMERTIMER
FAN TIMER
'
F
ON
O
FF
ON
O
FF
POWER
MODE
- Push this button to cycle through the modes from COOL → FAN 
→ HEAT→ COOL.
- COOL
• Fan runs continually for normal cooling operation.
- ENERGY SAVER
• The fan stops when the compressor stops cooling.
Approximately every 3 minutes the fan will turn on and the unit
will check the room air temperature to determine if cooling is
needed.
- FAN
• Fan operation without heating or cooling.
- HEAT
• Fan runs continually for normal heating operation.
TIMER
- SHUT-OFF TIME
• You will usually use shut-off time while you sleep.
• If unit is running, use Timer to set number of hours until shut-off.
• For your sleeping comfort, once Time is set, the Temperature setting will raise 2° F after 30 minutes, and once again
after another 30 minutes.
• Push Timer to cycle through the settings from 1 Hour → 2 Hours → ... → 12 Hours maximum.
TEMPERATURE SETTING
• Use this button to automatically control the
temperature of the room. 
The temperature can be set within a range of
54° F to 86° F by increments of 2° F. 
• The setting appears in the display.
FAN SPEED
• Every time you push this button, it cycles through the settings as follows:
{High(F2) → Low(F1) → High(F2) → Low(F1)}
• To turn the air conditioner ON, push this button. 
To turn the air conditioner OFF, push the button
again.
• This button takes priority over any other button.


LG LP096CD3A Specifications

General

Brand	LG
Model	LP096CD3A
Category	Air Conditioner
Language	English