3-12
COMPONENT ACCESS
REMOVING THE ST
REMOVING THE ST
ORAGE DRA
ORAGE DRA
WER
WER
To Remove Storage Drawer:
1. Open the drawer to the fully opened position.
2. Remove the 2 screws (right and left side). (refer
to below picture)
3. Locate glide lever
on each side of
drawer, push
down on the left
glide lever and pull up on the right glide lever.
5. Pull the Storage drawer away from the range.
To Replace the Storage Drawer:
1. Replace shield on the right glide of the drawer
body.
2. Pull the bearing glides to the front of the chassis
glide.
3. Align the glide on each side of the drawer with
the glide slots on the range.
4. Push the drawer into the range until levers “click”
(approximately 2”). Pull the drawer open again to
seat bearing glides into position. If you do not
hear the levers “click” or the bearing glides do not
feel seated remove the drawer and repeat steps
2-4. This will minimize possible damage to the
bearing glides.
WARNING
• DISCONNET power supply cord
from the outlet before servicing.
• Replace all panels and parts before
operating.
• RECONNECT all grounding devices.
- Failure to do so can result in severe personal
injury, death or electrical shock.
CAUTION
• Be careful when you work on the
electric range handling the sheet
metal part.
- Sharp edge may be present and you can cut
yourself.
To Next Page
Loading...
Need help?
General
