SURFACE CONTROLS COOKING
SETTING SURFACE CONTROLS
When changing from a high heat setting to a lower heat
setting, the surface unit may stop glowing. This is normal.
1. Touch ON/OFF for the desired
element position. The display will
flash .
(The display will disappear if not
used after 10 seconds.)
2. Touch once to turn on the
power level Hi or once for Lo.
3. Use the / to choose the
desired power setting.
/ is continuously accessible.
(Adjustable at any time while the
element is ON.)
4. To turn off the element after
cooking, touch ON/OFF once.
To turn on a single surface unit
(Right Rear, Left Rear, Left front)
3. Touch once to turn on the power
level Hi or once for Lo.
4. Use the / to choose the desired
power setting. / is continuously
accessible. (Adjustable at any time
while the element is ON.)
5. To turn off the element after cooking,
touch ON/OFF once.
1. Touch ON/OFF. The display will
flash .
(The display will disappear if not used
after 10 seconds.)
2. Touch SELECT for desired element
size.
To turn on a triple surface element
(Right Front Inner, Middle, Outer)
CAUTION
• DO NOT touch surface elements until it
has cooled down sufficiently.
- The surface elements may still be hot and burns may
occur.
CAUTION
• DO NOT touch surface elements until it
has cooled down sufficiently.
- The surface elements may still be hot and burns may
occur.
CAUTION
• NEVER leave food unattended at high or
medium-high setting.
- Boilovers can cause smoking and greasy spillovers
may catch on fire.
Setting
Size of Element
Single light
Double light
Triple light
• Single Element (6" element)
• Double Element (6" and 9"
elements)
• Triple Element (6", 9" and 12"
elements)
- 9 -
English
Español
To scroll through the power levels quickly press and
hold the or key pads until the power level
desired is reached.
Note:
To scroll through the power levels quickly press and
hold the or key pads until the power level
desired is reached.
Note:
To Next Page
Loading...
Need help?
General
