9
IMPORTANT SAFETY INSTRUCTIONS
•
Do not clean door gasket. The door gasket is essential for a good seal. Care should be
taken not to rub, damage, or move the gasket.
•
Excess spillage must be removed before cleaning.
•
If there is a fire in the oven during self-clean, turn the oven off and wait for the fire to go
out. Do not force the door open. Introduction of fresh air at self-clean temperatures may
lead to a burst of flame from the oven. Failure to follow this instruction may result in severe
burns.
•
Steam cleaner is not to be used.
COOK MEAT AND POULTRY THOROUGHLY
•
To protect against food-borne illnesses, cook meat and poultry thoroughly.
Using Oven Racks
•
The racks have a turned-up back edge that prevents them from being pulled out of the
oven cavity.
•
When removing racks, pull the rack straight out until it stops, and lift up the front of the
rack and pull it out.
•
When replacing racks, place the end of the rack on the support, and tilt the front end up
and push the rack in.
CAUTION
•
Replace oven racks before turning the oven on to prevent burns.
•
Do not cover the racks with aluminum foil, or any other material, or place anything on
the bottom of the oven. Doing so will result in poor baking and may damage the oven
bottom.
•
Only arrange oven racks when the oven is cool.
Installation Guide for Flicker (EN 61000-3-3 & EN 61000-3-11)
•
This device is intended for the connection to a power supply system with a maximum
permissible system impedance Z
MAX
of 0.2981 Ω at the interface point (power service box)
of the user’s supply. The user has to ensure that this device is connected only to a power
supply system which fulfills the requirement above. If necessary, the user can ask the
public power supply company for the system impedance at the interface point.
To Next Page
Loading...
Need help?
General
