Why will my LG LRG30355ST Ranges oven not self-clean?
If your LG Ranges oven will not self-clean, it could be because the oven temperature is too high. Allow the range to cool to room temperature before resetting the controls. Improperly set oven controls could also be the cause.
Why my LG LRG30355ST clock and timer do not work?
If the clock and timer on your LG range aren't working, consider the following: * Make sure the range is fully plugged into a live, properly grounded electrical outlet. * Check the fuse in your home. It may be blown, or the circuit breaker may be tripped. Replace the fuse or reset the circuit breaker if needed. * Verify that the oven controls are properly set.
What to do if clock flashes on LG LRG30355ST Ranges after power outage?
If the clock on your LG range is flashing after a power outage: Reset the clock. If the oven was in use, you must reset it by touching the CLEAR/OFF pad, setting the clock and resetting any cooking function.
What to do if LOCKED DOOR light is on when I want to cook on LG Ranges?
If the "LOCKED DOOR" light is on when you want to cook on your LG range, the oven door is locked because the temperature inside the oven has not dropped below the locking temperature. Touch the CLEAR/OFF pad and allow the oven to cool.
How to fix LG Ranges top burners that do not light or burn evenly?
If the top burners on your LG Ranges aren't lighting or burning evenly, ensure the electrical plug is fully inserted into a properly grounded outlet. Also, the burner slits might be clogged, so remove and clean them, checking for food or grease around the electrode area. Finally, confirm that all burner parts are correctly installed.
What to do if “F—and a number or letter” flash in the display of LG Ranges?
If you see “F—and a number or letter” flashing on the display of your LG Ranges, it indicates a function error code. First, try touching the CLEAR/OFF pad and allow the oven to cool for one hour before putting it back into operation. If the error repeats, disconnect power to the range for 5 minutes, then reconnect. If the error persists after this, call for service.
Why is the oven light not working on my LG Ranges?
If the oven light on your LG Ranges isn't working, start by checking if the bulb is loose or defective; tighten or replace it as needed. Also, verify that the range is fully plugged into a grounded electrical outlet.
Why is the clock and timer not working on my LG LRG30355ST Ranges?
If the clock and timer on your LG Ranges aren't working, make sure the range is properly plugged into a grounded electrical outlet. Check your home's fuse or circuit breaker and replace or reset it if necessary. If those aren't the issue, consult the 'Using the Clock and Timer' section to ensure the oven controls are correctly set.
Why does the display go blank on my LG LRG30355ST Ranges?
If the display on your LG Ranges goes blank, it could be due to a blown fuse or tripped circuit breaker in your home; replace the fuse or reset the breaker. Alternatively, the clock might be in black-out mode; refer to the Special Features of Your Oven Control section for instructions.
Why are the burner flames very large or yellow on my LG LRG30355ST?
If the surface burners on your LG Ranges have very large or yellow flames, it indicates an improper air to gas ratio. If your range is connected to LP gas, contact the installer or conversion specialist for assistance.
To Next Page
General
