Why my LG LRG30355ST clock and timer do not work?
If the clock and timer on your LG range aren't working, consider the following: * Make sure the range is fully plugged into a live, properly grounded electrical outlet. * Check the fuse in your home. It may be blown, or the circuit breaker may be tripped. Replace the fuse or reset the circuit breaker if needed. * Verify that the oven controls are properly set.
What to do if clock flashes on LG LRG30355ST Ranges after power outage?
If the clock on your LG range is flashing after a power outage: Reset the clock. If the oven was in use, you must reset it by touching the CLEAR/OFF pad, setting the clock and resetting any cooking function.
What to do if LOCKED DOOR light is on when I want to cook on LG Ranges?
If the "LOCKED DOOR" light is on when you want to cook on your LG range, the oven door is locked because the temperature inside the oven has not dropped below the locking temperature. Touch the CLEAR/OFF pad and allow the oven to cool.
How to fix LG Ranges top burners that do not light or burn evenly?
If the top burners on your LG Ranges aren't lighting or burning evenly, ensure the electrical plug is fully inserted into a properly grounded outlet. Also, the burner slits might be clogged, so remove and clean them, checking for food or grease around the electrode area. Finally, confirm that all burner parts are correctly installed.
What to do if “F—and a number or letter” flash in the display of LG Ranges?
If you see “F—and a number or letter” flashing on the display of your LG Ranges, it indicates a function error code. First, try touching the CLEAR/OFF pad and allow the oven to cool for one hour before putting it back into operation. If the error repeats, disconnect power to the range for 5 minutes, then reconnect. If the error persists after this, call for service.
Why is the oven light not working on my LG Ranges?
If the oven light on your LG Ranges isn't working, start by checking if the bulb is loose or defective; tighten or replace it as needed. Also, verify that the range is fully plugged into a grounded electrical outlet.
Why is food not broiling properly in the oven of my LG Ranges?
If your food isn't broiling properly in the oven of your LG Ranges, first ensure the oven controls are correctly set by touching the BROIL HI/LO pad. Make sure the oven door is closed. Use the proper shelf position, consulting the Broiling Guide. Use the broiling pan and grid that came with your range and ensure they are cool. Only use cookware suited for broiling. If using aluminum foil on the broiling pan and grid, ensure it's properly fitted and slit as recommended. Finally, check that the oven bottom is securely seated in position.
Why does the display go blank on my LG LRG30355ST Ranges?
If the display on your LG Ranges goes blank, it could be due to a blown fuse or tripped circuit breaker in your home; replace the fuse or reset the breaker. Alternatively, the clock might be in black-out mode; refer to the Special Features of Your Oven Control section for instructions.
Why are the burner flames very large or yellow on my LG LRG30355ST?
If the surface burners on your LG Ranges have very large or yellow flames, it indicates an improper air to gas ratio. If your range is connected to LP gas, contact the installer or conversion specialist for assistance.
What to do if the oven door will not open after a clean cycle on LG Ranges?
If your LG Ranges oven door won't open after a clean cycle, it's likely because the oven is still too hot. Allow it to cool below the locking temperature.
Essential safety information, warnings, and precautions for appliance operation.
Critical instructions for installing the anti-tip device to prevent range tipping.
General safety measures to prevent accidents during use.
How to light, use, and adjust gas surface burners and select flame size.
Using oven controls, bake, broil, convection, probe, timed cooking, and special modes.
Guides for using the warming drawer and self-cleaning the oven.
Tools, materials, safety precautions, and preparation before installation.
Required clearances, safety warnings, and anti-tip device installation.
Procedures for connecting the range to gas supply and electrical power.
Troubleshooting surface burner ignition and flame quality issues.
Addressing problems with oven temperature, baking, broiling, and cookware.
Resolving display errors, door lock issues, timer problems, and probe warnings.
Details on warranty period, covered repairs, and warranty exclusions.
How to prove warranty coverage and contact customer support.
To Next Page
General
