Strongly suspect items below If the issue remains yet, though all the diagnosis for icemaker has been carried out.
- Cap duct bad sealing
- Defective thermal sensor in the icemaker compartment
- Not cold icemaker compartment area (sealed system)
Clogged Ice In the Ice Bin (suspected items)
- Customer haven’t used ice dispenser over a week.
Resolution : the ices gets stuck if customer doesn’t use ice dispenser .
In this case, empty the ice bin and wait until the new ices are stacked in the ice bin.
- Temperature of icemaker compartment is not cold enough.
Resolution : Check ice fan, sealed system, cap duct, vent and other items related to temperature.
- Cap duct doesn’t seal the air properly.
Resolution : Possibly, warm air could get into the compartment and make ices get stuck. Replace the cap duct with
new one.
- In-door geared motor doesn’t work
Resolution : Change the in-door geared motor and test it.
- The water comes out of fill cup and the water get into the ice bin.
Resolution : The water pressure from shutoff valve is too high.
Recommend to use regulator to the customer and close the shutoff valve slightly.
Clogged Ices In the Chute (suspected items)
- Cap duct doesn’t seal the air properly.
Resolution : Possibly, warm air could get into the compartment and make ices get stuck. Replace the cap duct with
new one.
2
st
STEP (Ice-detecting sensor Diagnosis)
3.. Wait for 3m .1.. Remove Ice bin from compartme
4.. Freezer door stays op
. Push the refrigerat5.
button & lock button at the
same time.
2.. Close the left do
(Door switch pushed)
If ETY is shown on the display after the procedure above, Ice-detecting sensor is normal.
If FULL is shown on the display after the procedure above, Ice-detecting sensor is abnormal.
12-3-3 Icemaker not making ice or not making enough ice (Other suspected Items)
12-3-4 Not Dispensing Ice
-114-
Copyright © 2019 LG Electronics Inc.
All rights
reserved. Only training and service purposes.
To Next Page
Loading...
Need help?
General
