Operation procedures when the remote control can't be used.
Open the front panel upward and move the Slide Switch to the
Forced Operation position.
If you want to stop operation, move the Slide Switch to the Auto
Restart or the Remote Control position.
In case the power comes on again after power failure on the
Forced Operation position, the operating conditions are
automatically set as follows:
During Forced Operation, the initial mode continues.
In case the power comes on again after a power failure, Auto
Restarting Operation is the function to operate procedures
automatically to the previous operating conditions.
If you want to use this operation, Open the front panel upward and
move the slide switch to the Auto Restart position.
If you do not want to use this operation, move the Slide Switch to
the Remote Control position.
Forced Operation
Auto restart
Operating Instruction
Heat pump Model
Cooling Model
Room Temp. ≥ 24°C(75.2°F) 21°C(69.8°F) ≤ Room Temp. < 24°C(75.2°F)
Room Temp. <
21°C(69.8°F)
Operating mode Cooling Cooling Healthy Dehumidification Heating
Indoor FAN Speed
High High
Healthy Dehumidification Rule
High
Setting Temperature
22°C(71.6°F) 22°C(71.6°F) 23°C(73.4°F) 24°C(75.2°F)
When you are out for a while, put the
Slide Switch on the Remote Control.
Helpful information
Fan speed and cooling capacity.
The cooling capacity indicated in the specification is the
value when the fan speed is set to high, and the capacity will
be lower at low or medium fan speed.
High fan speed is recommended when you wish to cool the
room quickly.
To Next Page
Loading...
