12
Single Zone High Efciency and Standard Wall Mounted Owner’s Manual
Due to our policy of continuous product innovation, some specications may change without notication.
©
LG Electronics U.S.A., Inc., Englewood Cliffs, NJ. All rights reserved. “LG” is a registered trademark of LG Corp.
UNIT OPERATION
Remote Controller, Indoor Unit
Initializing Remote Controller Operation
To begin communication between the indoor unit and the remote control, point the remote control towards the signal receiver, located at the
bottom right hand corner of the indoor unit (refer to Figure 8).
•Make sure to point the remote controller directly at the indoor unit, otherwise
the remote may accidentally pick up a signal and activate and operate other
electronic devices.
•For optimum operation, periodically use a soft cloth to wipe the signal
transmitter on the remote control and the receiver on the indoor unit.
•Jet mode in heating operation does not work when equipped with a wired
remote controller.
•On/Off reserve mode does not work when equipped with a wired remote
controller.
Figure 8: Initializing a Remote Control
To Next Page
Loading...
Need help?
General
