1. Troubleshooting
TROUBLE DIAGNOSIS
- 57 -
CLAIMS. CAUSES AND CHECK POINTS. HOW TO CHECK
1. Faulty start
1) No power at outlet.
2) No power on cord.
3) Shorted start circuit.
4) During defrost.
* Measuring instrument:
Multi tester
■ Check the voltage.
If the voltage is within ±15%
of the rated voltage, it is OK.
■ Check the terminal
movement.
■
Check both terminals of
power cord.
Power conducts: OK.
No power conducts: NG
■ Check both terminals of
OLP
If power conducts: OK.
If not: NG.
■ Check the resistance of both
terminals.
At normal temperature 6:
OK.
If disconnected: ∞.
Bad connection between plug and adapter (faulty plug).
The distance between pins.
Pin outer diameter.
No power on
power cord.
OLP is off.
No electric power on compressor. - Faulty compressor.
Faulty PTC.
Disconnected copper wire.
Internal electrical short.
Faulty terminal contact.
Disconnected.
Capacity of OLP is small.
Characteristics of OLP is bad.
Bad connection.
Power is
disconnected.
Inner Ni-Cr wire blows out.
Bad internal connection.
Faulty terminal caulking (Cu wire is cut).
Bad soldering.
Weak connection.
Short inserted cord length.
Worn out tool blade.
Loose contact.
- Large distance between
male terminal.
- Thin female terminal.
Terminal disconnected.
Bad sleeve assembly.
Power cord is disconnected.
Faulty soldering.
Start automatic defrost.
Cycle was set at defrost when the refrigerator
was produced.
Power does not conduct. - Damage.
Bad characteristics. - Initial resistance is high.
Bad connection with
compressor.
Bad terminal connection.
Too loose.
Assembly is not possible.
To Next Page
Loading...
Need help?
General
