-6-
GENERAL
TO REDUCE THE RISK OF FIRE, USE ONLY METAL DUCTWORK.
To reduce risk of fire and to properly exhaust air outside - Do not vent
exhaust air into spaces within walls, ceilings, attics, crawl spaces or
garages.
No for use over an outdoor grill.
WARNING
CAUTION
OPERATION
Always leave safety grilles and filters in place. Without these components, operating blowers could catch
onto hair, fingers and loose clothing.
The manufacturer declines all responsibility in the event of failure to observe the instructions given here
for installation, maintenance and suitable use of the product. The manufacturer further declines all
responsibility for injury due to negligence and the warranty of the unit automatically expires due to
improper maintenance.
ELECTRICAL REQUIREMENTS
Important:
Observe all governing codes and ordinances.
It is the customer’s responsibility:
- To contact a qualified electrical installer.
- To assure that the electrical installation is adequate and in conformance with National Electrical Code,
ANSI/NFPA 70 latest edition* or CSA standards C22.1-94, Canadian Electrical Code, Part 1 and C22.2
No.0-M91 - latest edition** and all local codes and ordinances.
If codes permit and a separate ground wire is used, it is recommended that a qualified electrician
determine that the ground path is adequate.
Do not ground to a gas pipe.
Check with a qualified electrician if you are not sure the range hood is properly grounded.
Do not have a fuse in the neutral or ground circuit.
*National Fire Protection Association Batterymarch Park, Quincy, Massachusetts 02269
** CSA International 8501 East Pleasant Valley Road, Cleveland, Ohio 44131-5575
This appliance requires a 120V 60Hz electrical supply and connected to an individual properly grounded
branch circuit
protected by a 15 or 20 ampere circuit breaker or time delay fuse. Wiring must be 2 wire with ground.
Please also refer to Electrical Diagram on product.
A cable locking connector(not supplied) might also be required by local codes. Check with local
requirements, purchase and install appropriate connector if necessary.
To Next Page
Loading...
Need help?
General
