Safety precautions
6 Ventilator
The following content is for models with the UVnano function.
• Be sure to turn off the main power for installation, service, and repair of the
UV LED.
- It may cause electric shock, injury, or death.
• When installing, servicing, or repairing the UV LED, the modules provided
by LG Electronics must be used. If necessary, please contact an LG
Electronics Service Center.
* UV LED Module Information : LTPL‑G35U275GS‑TWA, HTV11ECM-
ASQ1-11B1, HTV11ECM-ASQ1-11C1
• This product is equipped with a UV‑C lamp (UV LED). Do not stare at the
UV LED.
- Injury may occur.
• If the UV LED is damaged or needs to be replaced, please contact an LG
Electronics Service Center.
- Injury may occur.
• Do not operate the UV LED outside the product.
- Injury may occur.
• Do not remove the parts inside the product with UV risk symbols. UV C
may be released from the UV LED.
- Injury may occur.
• Be careful as UC V may be released to the outside due to unintended use
of the product or damage to the product. UV C can harm the eyes and skin
even if the exposure is small.
• Do not touch or clean the product while the UVnano function is operating.
• The UV LED is a part that does not require cleaning. Do not separately
clean parts with UV risk labels or the UV LED.
- Injury may occur.
• UVnano is a compound word of UV(ultraviolet)LED and nanometers, the
unit of ultraviolet wavelength.
• When the product is powered off or the access door is opened, the UVnano
sterilization function stops.
• If UV LED repair is required while using the UVnano function, a UV
indicator occurs on the remote controller.
• Depending on the model, some functions may not be displayed/operate or
be different.
To Next Page
Loading...
