Safety precautions
Installation manual 7
ENGLISH
• This appliance contains a UV emitter. Do not stare at the light source.
• Doors and access panels bearing the ultraviolet radiation hazard symbol
which may have UV-C spectral irradiance greater than 1,7 μW/cm
2
are
provided with an interlock switch to interrupt the power to the UV-C lamps
for your safety. Do not over-ride.
• UV-C barriers bearing the ultraviolet radiation hazard symbol should not be
removed.
• For appliances with UV-C lamps, information on the replacement of UV-C
lamps shall be given, including the model and/or part number.
• If field installed, the factory specified UV-C germicidal lamp systems
approved for use with the subject product shall be specified in the
instructions by the specific model number.
• This appliance is not intended to be accessible to the general public.
• If the supply cord is damaged, it must be replaced by the manufacturer, its
service agent or similarly qualified persons in order to avoid a hazard.
Installation
• Don't connect the ground wire to the window frame or water cock.
- There is risk of electric shock.
• Do not install the product at a smoky and oily place like kitchen or factory.
-
Otherwise. oil may adhere to the filter or heating exchanger and cause trouble.
• Install the product in an insulated space from outdoor air.
- In case of installing the product outside of the insulated layer, dewing
occurs inside of the main body in winter.And it causes electrical shock or
falling of condensed water.
• Keep level even when installing the product.
- To avoid vibration or water leakage.
• Use two or more people to lift and transport the product.
- Avoid personal injury.
• Do not install the product where it will be exposed to sea wind (salt spray)
directly.
- It may cause corrosion on the product. Corrosion, particularly on the
condenser and evaporator fins, could cause product malfunction or
inefficient operation.
CAUTION
!
To Next Page
Loading...
