LG M2901S - Page 42

Controlling the Multiple Product
RS-232C
A11
Transmission / Receiving Protocol
29. Serial No.(Command : f y)
► To read the serial numbers.
Transmission Acknowledgement
Data FF (to read the serial numbers)
30. S/W Version(Command : f z)
► Check the software version.
Transmission Acknowledgement
Data FFH : Read
31. Product Type(Command : f v)
► Check the product type.
Transmission Acknowledgement
Data FFH : Read
32. Model Name(Command : f w)
► Check the model name.
Transmission Acknowledgement
Data FFH : Read
33. Orbiter / White Wash(Command : j p)
► Used to select the afterimage preventing function.
Transmission Acknowledgement
Data 2H : Orbiter
4H : White Wash
8H : Normal
* If you select Normal, it will recover to original image.
[f][y][][Set ID][][Data][Cr]
[f][z][][Set ID][][Data][Cr]
[f][v][][Set ID][][Data][Cr]
[f][w][][Set ID][][Data][Cr]
[j][p][][Set ID][][Data][Cr]
28. V-Position (Command : f r)
► To set the Vertical position.
Transmission Acknowledgement
* The data range is from 00 to 64(in Hex)
[f][r][][Set ID][][Data][Cr] [r][][Set ID][][OK/NG][Data][x]
[y][][Set ID][][OK/NG][Data][x]
[z][][Set ID][][OK/NG][Data][x]
[v][][Set ID][][OK/NG][Data][x]
[w][][Set ID][][OK/NG][Data][x]
[w][][Set ID][][OK/NG][Data][x]