_ Turn on power by pressing the power button on the product.
(_Turn on the PC.
T
Power button
Select an input signal.
Press the INPUT button on the remote control to select the input signal.
( INPUT _ •,&--* SET ")
J
Or, press the SOURCE button on the back of the product.
SOURCE ---* • A ---_ AUTO/SET )
'il/ iiiiii]i!iiiiiiliiii!iiiliiiiilHliHlliii i iiii!iiiiiii/iiJiii!! i t!iiijiHiilHi!!!/i!li]!
(_ When connecting with a D-Sub signal input cable. _ _" ] ]
• Select RGB PC: 15-pin D-Sub analog signal.
(_When connecting with a HDMI to DVl signal input cable.
• Select HDMIiDVI : HDMI to DVI Digital signal.
I • How to connect to two computersl
/Note I Connect the signal cables (HDM! to DV! and D,Sub)to each computert
I Press the !a PUT button on the [emote control to select the computer to use_
° Directly connect to a grounded power outlet on the wall or a power bar with a ground
w!re:
To Next Page
Loading...
