22
Troubleshooting
Symptom
Cause Correction
No power
POWER
The power cord is not plugged in.
Plug in the power cord.
No sound
Some noise occurs.
RADIO
The function switch is not set to the Radio mode.
There are electronic devices near the unit.
The antenna is positioned or connected poorly
Set the switch to the Radio mode.
Set the unit far from the devices.
Check the antenna connection and adjust its position
The unit does not start
playback
No picture
DVD/CD
An unplayable disc is inserted.
The disc is placed upside down.
The disc is not placed within the guide.
The TV is not set to receive the video signal
Insert a playable disc.
Place the disc with the playback side down.
Place the disc on the disc tray correctly inside the guide.
Clean the disc.
Select the appropriate video input model on the TV so the
picture from the unit appears on the TV
Unable to record
TAPE
Record protect tabs are removed. Cover holes on back edge of tape with tap.
REMOTE CONTROL
The remote control is not pointed at the remote sensor of
the unit directly.
Point the remote control to remote sensor directly of the
unit.
The remote control does
not work properly.
The battery in the remote control is exhausted. Replace the battery with new ones.
To Next Page
Loading...
Need help?
General
