Installation Manual 7
Safety Precautions
ENGLISH
Do not install the outdoor unit at the outside
of apartment balcony or veranda or the site
of the same installation condition
Do not install the unit beside or on the footway
which may be flooded or submerged and may
be an obstructions for pedestrians to walk.
- In case that inevitably
install the unit beside the
footway, it may cause a
problem for your neigh-
bors.
Do not install the unit on a structure that may
cause leakage.
- When the room humidity
exceeds 80% or when the
drain pipe is clogged, con-
densation may drip from the
indoor unit. Perform collec-
tive drainage work together
with the outdoor unit, as
required.
Take measures to prevent children from
touching the unit.
- Injuries such as cuts could occur if a child
touches the surface of the fins on the heat
exchanger.
Cautions for electrical work and movement
Ground the unit.
- Do not connect the
ground wire to gas or
water pipes, lightning
rods, or telephone
ground lines. Improper
grounding may result in
electric shock.
Install the power cable so that tension is not
applied to the cable.
- Tension may cause the
cable to break and gen-
erate heat and cause a
fire.
Install a leakage circuit breaker, as required.
- If a leakage circuit breaker is
not installed,
electric shock may result.
Use power cables of sufficient current carry-
ing capacity and rating.
- Cables that are too small
may leak, generate heat,
and cause a fire.
To Next Page
Loading...
Need help?
General
