1
4
5
7
11
10
9
8
2
3
6
13
12
14
15
Attach the appropriate language information label
inside the front door for convenient access.
Owner’s & Installation Manual 5
4 New Wide Wired Remote Controller
Installation Instructions
2
2
1
3
3
1. Please fix tightly using the provided screws after placing remote controller setup
board on the place where you plan to place the remote controller.
- Please set it up not to bend because poor setup could take place if setup board bends.
Please set up remote controller board fit to the reclamation box if there is a reclamation box. is unclear and
needs to be heavily reworded.
- Install the product so as not to make a gap with the wall side to prevent shaking after the installation.
2. The wired remote controller can be set up in three different directions.
- Direction: through the wall, top, or right.
- If setting up the remote controller cable to exit through the top or right side, be sure to remove the plastic from
the guide grooves from the remote controller case.
Remove guide groove with long nose.
①
Through the wall
Through the top
Through the right side
Installation Instructions
Part Description
Part Description
Name and Function of Remote Controller
OPERATION INDICATION
SCREEN
SET TEMPERATURE BUTTON
FAN SPEED BUTTON
ON/OFF BUTTON
OPERATION MODE SELECTION
BUTTON
WIRELESS SIGNAL (IR)
RECEIVER FOR WIRELESS
REMOTE CONTROLLER
• Only Operate with ceiling Duct
type indoor unit
AIR FLOW BUTTON
SUBFUNCTION BUTTON
FUNCTION SETTING BUTTON
VENTILATION BUTTON
RESERVATION
UP,DOWN,LEFT,RIGHT BUTTON
• To check the indoor temperature,
press button.
ROOM TEMPERATURE BUTTON
SETTING/CANCEL BUTTON
EXIT BUTTON
1
2
3
4
5
6
7
8
9
10
11
12
13
14
15
Connection Cable
(1EA, 10m)
Screw
(4 EA)
Owner's / Installation
manual
Inform label
(8EA-8Languages)
Accessories
Some functions may not be operated and displayed depending on the product type.
Wire guide grooves
To Next Page
Loading...
Need help?
General
