Connecting22
Connecting
2
Connecting the
speaker to your Home
Network
Using a wired network provides the best
performance, because the attached devices
connect directly to the network without radio
frequency interference.
Please refer to the documentation for your network
device for further instructions.
Preparation
y
Make sure that wireless network environment
using a router is installed at your home.
y
Make sure that the speaker and the smart device
are connected to the same router.
Requirements
y
Wireless router
y
Smart device (Android or iOS)
y
Make sure that DHCP’s server is activated on
wireless router.
y
If you cannot connect the speaker with your
router, go to setting of the router and then
make sure that “Allow wireless client to see
each other and access my local network”
box is unchecked.
,
Note
Simple Connection (EZ Setup)
Preparation
y
For Simple Connection, Wi-Fi network condition
is needed.
y
Make sure that the Bluetooth setting on your
smart device in on.
y
Simple Connection is supported by
Bluetooth Ver 4.0 (or higher).
y
If Simple Connection screen is not displayed
on the screen, connect the unit by the other
way. Please refer to “Connecting the speaker
to your network with a LAN cable” (page 23)
or “Connecting the speaker to your Network
via the Wi-Fi Setup Method” (page 25 or page
28)
,
Note
1. Plug in the desired device, and tap [Next].
2. App searches for the speaker and connects it
automatically, Tap [Next].
3. If the network password is set, security screen is
displayed. Type the password.
To Next Page
Loading...
