17
EN
Smart Mode (invalid for some
models) a
Press the Smart button, the unit enters Smart mode(fuzzy logic
operation). In this mode, temperature and fan speed are automatically
set based on the actual room temperature.
For the split-type models, such as wall-mounted air conditioners and
some floor-standing air conditioners, their operation mode and set
temperature should be determined based on the indoor temperature.
Heat Pump Models
Indoor temperature Operation mode Target temperature
21
°C
or below Heating
22 °C
21
°C - 23 °C
Fan Only
23
°C - 26 °C
Dry
Room temperature
decrease 2
°C
after
operate for 3
minutes
Over 26
°C
Cooling
26 °C
Cooling Only Models
Indoor temperature Operation mode Target temperature
23 °C
or below Fan Only
23
°C - 26 °C
Dry
Room temperature
decrease 2
°C
after
operate for 3
minutes
Over 26
°C
Cooling
26 °C
NOTE
• The operation mode is determined by the difference between the
indoor temperature and set temperature.
• Smart button is ineffective in Jet mode. Press Mode button
cancel Smart mode.
• Temperature, airflow and direction are controlled automatically in
Smart mode. However, For the on/off, you can choose from -2 to
2 (for some models you can choose from -7 to 7), for the inverter
you can choose from -7 to 7. if you still feel uncomfortable.
Dual
Sensing
Mode
Light
Off
Fan
Speed
Smart
Cloc
leep
Swing Swing
Jet
Mode
Room
Temp
Timer
Off
Timer
On
Temp.
To Next Page
Loading...
