LG NB3740 - Wireless Subwoofer Connection; Pairing Wireless Subwoofer; Setting Up Wireless Subwoofer

Connecting 13
Wireless Subwoofer
Connection
Pairing wireless subwoofer
LED indicator of wireless subwoofer
LEDColor Status
Yellow-green The connection istrying.
(Blink)
Yellow-green The connection iscompleted.
Red The wireless subwoofer is
in standby mode or the
connection isfailed.
Off (No The power cord of wireless
display) subwoofer is disconnected.
Setting up the wireless subwoofer
for the first time
1. Connect the power cord of the Wireless
subwoofer to the outlet.
2. Turn on the main unit :The main unit and
wireless subwoofer will be automatically
connected.
Manually pairing wireless subwoofer
When your connection is not completed, you can
seethe red LEDor the blinking of yellow-green LED
on the wireless subwoofer and the subwoofer does
not make sound.To solve the problem, follow the
below steps.
1. Adjust volume level of the main unit to
minimum.
- "VOLMIN'appears on the display window.
2. Pressand hold MUTE(]_I_) on the remote
control for about 3 seconds.
- "WL RESET"appearson the display window
briefly.
4.
5.
®
if the LED of the wireless subwoofer already
blinks in yellow-green continually, you can skip
this step.
Press and hold PAIRING on the back of the
wireless subwoofer for more than 5 seconds.
- The LED of the wireless subwoofer lights up
alternately in red and yellow-green.
Disconnect the power cord of the main unit
and the wireless subwoofer.
Connect them again after the LED of the main
unit and the wireless subwoofer is fully turned
off.
The main unit and the wireless subwoofer will
be paired automatically when you turn on the
main unit.
- When the connection is completed, you can
see the yellow-green LED on the subwoofer.
@ Note
It takes a few seconds (and may take longer)
for the main unit and the subwoofer to
communicate with each other and make
sounds.
The closer the main unit and the subwoofer,
the better sound quality. It is recommended
to install the main unit and the subwoofer
as close as possible (within 5 m) and avoid
the cases below.
- There is a obstacle between the main
unit and the subwoofer.
- There is a device using same frequency
with this wireless connection such as a
medical equipment, a microwave or a
wireless LAN device.
©
o