Energy Control mode
It is Brings the effect of the power saving.
(Setting available in air cooling mode)
1 step : The power Input in cooling mode
is decreased by 20% compared
to rated power Input
2 step : The power Input in cooling mode
is decreased by 40% compared
to rated power Input
1
Press | to turn the power on.
2 Press
B
.
-
J is displayed on the display screen.
Energy Control Function available under the
below temperature set
- Cooling-possible temperature range: Indoor
18°C (64°F) ~ 30°C (86°F), Outdoor 21°C
(69.8°F) ~ 32°C (89.6°F)
- Heating-possible temperature range: Indoor
16°C (60°F) ~ 30°C (86°F), Outdoor 6°C
(43°F) ~ 24°C (75°F)
Display screen brightness
You can adjust the brightness of the indoor
unit display screen.
1 Press \ to turn on/off the display screen.
Operating the air conditioner
without the remote control
You can use the On/Off button of the indoor
unit to operate the air conditioner when the
remote control is unavailable. However, the
fan speed is set to high.
1 Open the front cover.
- Lift up both sides of the cover slightly.
2 Press the On/Off button.
- For cooling and heating models, the oper-
ation mode changes, depending on the
room temperature.
15
ADVANCED FUNCTIONS
ENGLISH
NOTE
!
This function may not be supported,
depending on the model.
* The feature can be changed according a
type of model.
* The feature can be changed according a
type of model.
1 Step Entrance
2 Step Entrance
NOTE
!
• In Cooling mode, this function can be
used.
• Every time E/Control on wireless remote
controller is pressed, 1Step, 2Step, func-
tions release are repeated and switched
Wanted temperature appears for 5 sec.
• Capacity may decrease when outdoor
unit Energy Control mode is selected.
To Next Page
Loading...
