5
SAFETY INSTRUCTIONS
CAUTION
y
When placing the projector on a table
or shelf, be careful not to put it near
the edge.
- The projector could fall due to
balance problems, which may
cause personal injury or damage to
the product. Make sure to use the
projector cabinet or stand that fits the
projector.
y
When moving the projector, make
sure to switch it off and remove the
power plug and cords.
- The power cord may be damaged,
resulting in fire or electric shock.
y
Do not place the projector on an
unstable or vibrating surface such as
a wobbly shelf or a slope.
- It may fall and cause injury.
y
Be careful not to tip the projector over
when connecting external devices to
the projector.
- This may cause personal injury or
damage to the projector.
Power
WARNING
y
The appliance coupler is used as the
disconnect device. Please make sure
the device is installed near the wall
outlet to which it is connected and
that the outlet is easily accessible.
y
The grounding wire should be
connected.
- Ensure that you connect the
grounding cable to avoid electric
shock.
If it is not possible to ground the unit,
have a qualified electrician install a
separate circuit breaker.
Do not try to ground the projector
by connecting it to telephone wires,
lightning rods or gas pipes.
y
The power plug should be inserted
fully into the power outlet.
- An unstable connection may cause
a fire.
y
Do not place heavy objects on the
power cord.
- This may result in fire or electric
shock.
y
Never touch the power plug with wet
hands.
- This may result in electric shock.
y
Do not plug too many devices into
one multi-power outlet.
- This may result in fire due to the
power outlet overheating.
y
Prevent dust from collecting on the
power plug pins or outlet.
- This may result in fire.
To Next Page
Loading...
Need help?
General
