69
CUSTOMIZING SETTINGS
OPTION 2 Settings
1
Press the SETTINGS button.
2
Use the , , , or button to select
OPTION 2 and press the OK button.
3
Use the , , , or button to set up the
desired item and press the OK button.
- To return to the previous menu, press the
button.
4
Press the EXIT button when completed.
The available option 2 settings are described as follows.
Item Description
Keystone To prevent the screen image from becoming trapezoidal,
Keystone adjusts the top and bottom width of the image if the
projector is not set at a right angle to the screen.
Auto Keystone Auto Keystone provides a rectangular screen image by
automatically adjusting the Keystone number when there is a
trapezoidal screen image caused by tilting of the projector.
Item
On Automatically adjusts the Keystone number.
Off Manually adjusts the Keystone number.
PJT Mode
This function turns the projected image upside down or ips horizontal.
y
Select Rear when projecting from the back of the transparent
screen purchased separately.
y
Select Front Ceiling when installing the product on the ceiling.
y
When PJT Mode is Rear/ Front Ceiling, the left/right of the
speaker changes automatically.
High Altitude If the projector is used at an altitude higher than 1200 metres,
turn this on.
Otherwise, the projector may overheat or its protection function
may be activated. If this happens, turn the projector off and then
on again after waiting for several minutes.
Blank Image Selects a background for blank Image.
OP
y
- +
y
Auto
y
y
y
Blank Image
y
y
To Next Page
Loading...
Need help?
General
