LG Packaged Terminal Air Conditioner - Cross Flow Fan; Axial Fan

- 16 -
Copyright ©2008 LG Electronics. Inc. All right reserved.
Only for training and service purposes
LGE Internal Use Only
Figure 12
2.2.2 CROSS FLOW FAN
1. Remove the front grille. (Refer to section 2.1.1)
2. Remove the control box assembly.
(Refer to section 2.1.2)
3. Remove the Air-Guide Assembly from the unit.
(Refer to section 2.2.1)
4. Loosen the screw on the cross flow fan.
(See Figure 9)
5. Remove the 4 screws which fasten the indoor
motor and the earth wire. (See Figure 10)
6. Remove the supports on both sides.
7. Pull the cross flow fan out from the air-guide.
8. Re-install the components by referring to the
removal procedure.
2.2.3 AXIAL FAN
1. Remove the brace.
2. Remove the 4 screws which fasten the condenser
with the shroud and the basepan. (See Figure 11)
3. Remove the condenser sideways carefully.
4. Remove the clamp which secures the fan with
pliers.(See Figure 12)
5. Remove the axial fan.
6. Re-install the components by referring to the
removal procedure.
Figure 9
Figure 10
Figure 11