SAFETY INSTRUCTIONS
3
ENGLISH
• Securely attach the electrical part cover to AHU Comm. Kit.
- If the electric part cover of AHU Comm. Kit is not attached
securely, it could result in a fire or electric shock due to dust,
water, etc.
• Do not keep or use flammable gases or combustibles near the
equipment.
- Otherwise, it may cause a fire or the failure of product.
• Do not install, remove or reinstall the unit by yourself.
- Otherwise, it may cause a fire, electrical shock, explosion or
injury.
• Do not disassemble or repair the product randomly.
- It will cause a fire or electrical shock.
• Do not install the product in a place where there is the concern of
falling down.
- Otherwise, it may result in personal injury.
• Use caution when unpacking and installing.
- Sharp edges may cause injury.
• Always ground the product.
- There is risk of fire or electric shock.
• Do not install the product on a non-parallel or defective
installation stand.
- It may cause injury, accident, or damage to the product.
Operation
• Keep flames away.
- Otherwise, may occur a fire.
• Do not use the power cord near the heating tools.
- Otherwise, it may cause a fire and electrical shock.
• Do not allow water to run into electrical parts.
- Otherwise, it may cause the failure of machine or electrical
shock.
• Be cautious that water could not enter the product.
- Otherwise, it may cause a fire electrical shock or product
damage.
To Next Page
Loading...
Need help?
General
