10
AHU CONTROL KIT INSTALLATION
ENGLISH
- When using wall mount brackets, fasten the brackets to
the four holes on the rear of the enclosure.
- Please use the provided bolts, nuts, and washers to
fasten the brackets.
CAUTION
!
• When installing the control kit, make sure to leave at least 900 mm between the wall and
the product case so there is enough room for servicing and installation.
• After mounting the product, check whether it is properly affixed.
• If the control kit has to be installed outdoors, be sure to also install an enclosure.
• When installing load devices such as AHU sensors and dampers outdoors, fitted covers
must also be mounted to protect them from the effects of the external environment.
2626
486
552
<Back Side of Control Kit>
AHU CONTROL KIT INSTALLATION
Determining the product's mounting location
- The control kit's mounting location should be determined based on the conditions on site.
When mounting the control kit, use Ø 6 direct screws (8 EA).
To Next Page
Loading...
