14 Wireless Remote Controller
How to use the Mode Selection Button
NANO PLASMA Purification Operation (Optional)
PLASMA Air Purifying Operation only
Press the Start/Stop button.
The unit will respond with beep sound.
Open the door on the Remote
Controller. Press the PLASMA air
purifying operation ON/OFF button.
Operation will start when the button
is pressed and stop when the button
is pressed again.
Set the fan speed. You can select the fan speed in
four steps-low, medium, high or CHAOS.
Each time the button is pressed, the fan speed
mode is shifted.
❈ Air purifying operation (PLASMA) is
available in Heating or any other operations.
1
2
3
If you press the PLASMA button, NANO PLASMA
air purifying operates.
Each time the button ( ) is pressed, the fan
speed mode is shifed.
To Next Page
Loading...
Need help?
General
