15
ENGLISH
10. [Sharpness] (Command: k k)
ʢ To adjust the screen sharpness.
You can also adjust [Sharpness] in the [Picture] menu.
Transmission (k)(k)( )(Set ID)( )(Data)(Cr)
Data Min: 00 - Max: 32
Ack (k)( )(Set ID)( )(OK/NG)(Data)(x)
11. OSD Select (Command: k l)
ʢ Selects the on/off of On-Screen Display (OSD) that shows the control
status on the screen.
Transmission (k)(l)( )(Set ID)( )(Data)(Cr)
Data 00: OSD off 01: OSD on
Ack (l)( )(Set ID)( )(OK/NG)(Data)(x)
12. Remote Control Lock Mode (Command: k m)
ʢ To lock the buttons on the projector and remote control.
Transmission (k)(m)( )(Set ID)( )(Data)(Cr)
Data 00: Lock off 01: Lock on
Ack (m)( )(Set ID)( )(OK/NG)(Data)(x)
* If you are not using the remote control and projector buttons, use this mode.
When main power is off & on (plug-off and plug-in, after 20 - 30 seconds),
external control lock is released.
* In the standby mode (DC off by off timer or ‘ka’, ‘mc’ command), and if key lock is
on, Projector will not turn on by power on key of IR & Local Key.
To Next Page
Loading...
