LG ProCentric 55UV560H - Manual Pro:Centric Configuration

22
206-4326
EZ-Manager Wizard (Cont.)
(Continued on next page)
Manual Pro:Centric Conguration
1. With the Searching for Pro:Centric Server screen on display, use the Left/Right arrow keys on
the Installer Remote to select MANUAL PRO:CENTRIC at the bottom right of the screen, and
then press OK.
In the Pro:Centric Manual Conguration screen (see examples below), you will be able to
congure the appropriate Pro:Centric settings in the TV. Use the Up/Down arrow keys on the
Installer Remote to navigate between elds.
PRO:CENTRIC MANUAL CONFIGURATION
Pro:Centric Mode
Media Type
Data Channel
Signal Strength
Signal Quality
<
CONFIGURATION ONLY
>
< RF >
< 1 >
0%
0%
data channel not found
BACK
SEARCH
03
X
PRO:CENTRIC MANUAL CONFIGURATION
Pro:Centric Mode
Media Type
Server Address
IP Address
IP Port
0
0 0 0
0
IP server not found
BACK
SEARCH
<
CONFIGURATION ONLY
>
< IP >
< IP Address >
03
X
2. In the Pro:Centric Mode eld, use the Left/Right arrow keys to select the appropriate Pro:Centric
Application Mode—FLASH, GEM, or CONFIGURATION ONLY.
Note: For remote management only, select CONFIGURATION ONLY. The TV will search for
TV E-Z Installation data downloads; however, Pro:Centric application data will not be downloaded,
i.e., Installer Menu item 098 PRO:CENTRIC will be set to 0.
3. Refer to the appropriate subsection below, depending on the Pro:Centric server conguration,
to complete the remaining elds.
Pro:Centric Manual Configuration Screen
with RF Media Fields
Note: By default, the Pro:Centric Manual
Conguration screen initially shows RF
conguration elds.
Pro:Centric Manual Configuration Screen
with IP Media Fields