Operating Instructions
In this operation mode the actual setting temperature and the fan speed
are automatically set by the electronic control logic based on the current
room temperature. If you feel hot or cold press the temperature setting
NOTE : You cannot set the actual setting temperature and the indoor fan
speed in this operation mode. But you can use the Chaos swing
in this operation.
If the system is not operating as desired, switch manually to
another mode.
To run the auto operation follow steps 1, and 2. (See operation mode)
temperature.
In this case, however, the setting temperature is not displayed on the remote
controller and you are not able to control the room temperature either.
During the healthy function, the volume is
automatically set according to the optimization algorithm responding to the
current room temperature status, so that the room condition is kept healthy
and comfortable even in the very humid season.
1, and 2 and 4
(See operation mode)
AUTO CLEAN
During auto clean function, only START/STOP BUTTON, PLASMA BUTTON and AUTO CLEAN BUTTON
can be used.
NOTE
operation can be removed.
1. Press the AUTO CLEAN BUTTON to activate this function.
2.
closed.
3. This dries up any remains of moisture & cleans the unit internally.
4. If you press AUTO CLEAN BUTTON again during operation, this function is
cancelled.
Owner’s Manual 11
Auto Operation
ENGLISH
Healthy Dehumidication Operation
Auto Clean Operation
To Next Page
Loading...
Need help?
General
