EasyManuals Logo

LG S10INV-2 User Manual

LG S10INV-2
42 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #9 background imageLoading...
Page #9 background image
Operating Instructions
ON
OFF
CANCEL
AUTO CLEAN
SET
1
3
5
4
8
9
11
14
6
2
7
13
10
12
Flip-up door
(opened)
Signal transmitter
15
PLASMA
The controls will look like the following.
1. START/STOP BUTTON
2. OPERATION MODE SELECTION BUTTON
Used to select the operation mode.
Used to turn O/On the unit.
3. ROOM TEMPERATURE SETTING BUTTONS
Used to select the room temperature.
4. INDOOR FAN SPEED SELECTOR BUTTON
Used to select fan speed in four steps
low, medium, high and CHAOS.
5. JET COOL BUTTON
Used to start or stop the speed cooling.
(It operates fan in super high speed in cooling mode)
6. ON/OFF TIMER BUTTONS
Used to set the time of starting and stopping
operation.
7. TIME SETTING BUTTONS
Used to adjust the time.
8. TIMER SET/CANCEL BUTTON
Used to set and to cancel the timer operation.
9. SLEEP MODE AUTO BUTTON
Used to set sleep mode auto operation.
10. ENERGY-SAVING COOLING MODE BUTTON
Used to set energy-saving cooling mode operation.
11. ROOM TEMPERATURE CHECKING BUTTON
Used to check the room temperature.
13. RESET BUTTON
Used prior to resetting time.
14. 2nd F BUTTON
Used prior to using modes printed in blue at the
bottom of buttons.
15. AUTO CLEAN BUTTON
Used to set auto clean mode.
In some models this button has a 2nd function of LED
luminosity control.
To use the functions printed in blue at the bottom of the
buttons press 2 F button rst and then the required
nd
function button. Pressing the 2
nd
F button activates the
blue printed function of the respective button. To cancel
the function press the 2nd F button again else it will
automatically cancel if remains idle after 10 seconds.
NOTE
12. CHAOS SWING BUTTON
Used to stop or start louver movement and
set the desired up/down airow direction.
Cooling Operation
Auto Operation or Auto Changeover
Operation Mode
16
16. LED LUMINOSITY BUTTON
Used to adjust LED luminosity.
17. HORIZONTAL AIRFLOW DIRECTION
CONTROL BUTTON
Used to set the desired horizontal airow direction.
18. PLASMA BUTTON
Used to start or stop the Plasma-Purication
and Ion-Generation function.
Owner’s Manual 9
17
18
ENGLISH
Wireless Remote Controller

Table of Contents

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the LG S10INV-2 and is the answer not in the manual?

LG S10INV-2 Specifications

General IconGeneral
BrandLG
ModelS10INV-2
CategoryAir Conditioner
LanguageEnglish

Related product manuals